How to DIY Regrout Bathroom Tiles?

Are your bathroom tiles looking old and dull? Instead of considering installing new tiles, you should try regrouting and cleaning the tiles.

In most cases, regrouting can make your tiles look as good as new. If your tiles are in good condition, then regrouting is all you need to extend their life and restore their aesthetics.

And the best thing about tiles regrouting is, you don’t need professional assistance for doing that. If you just know how the regrouting process works, you can take care of that all by yourself.

The overall process is simple, you just need to remove the old grout and install the new one. Still, if you want professional services, you can go with the services Bathroom Surgeon Review and consider their regrouting services.

In this article, we are going to share with you the step-by-step guide for bathroom tiles regrouting to help you do a quality regrouting finish for your bathroom by yourself.

Let’s get straight to it

How to DIY Regrout Bathroom Tiles – Step by Step Guide

Step 1: Remove the Old Grout – There are a lot of grout removal tools out there that you can use to remove the old grout from your tiles. These tools include a blade that is designed to help you get rid of the old grout. You can use the tool along the grout joints to remove it.

Step 2: Clean the Grout Lines – Once you feel like you have removed most of the grout, you need to further clean the grout lines. You need to be careful in this step and get closer to the edges of the tiles. The whole point of this step is to get rid of the grout as much as possible.

Step 3: Vacuum to Complete Remove the Grout – When you are done removing the grout, you need to vacuum the tiles to get rid of the remnants. The vacuum is also going to help dry the tiles. Once you are done vacuuming the place, you are all set and ready to apply the grout. The Best Quietest Bathroom Fans with Light can also be used to clean off the dirt and dust from the tiles.

Step 4: Prepare the Grout – You can get the grout in powdered form or the form of a semi-liquid paste. Get the one that works the best for you and prepare it as per the instructions that you get with it. You need to make sure that you mix the grout well and in the right way if you want long-term results.

Step 5: Fill the Grout Joints – You need to use a rubber grout float to scoop up the grout for placement. You need to smear it on the surface of the tile. After that, you need to press the grout completely into the joints. Remove the excess grout from the joints and apply it to the next place. Repeat the process for regrouting all the tiles.

Step 6: Sponge the Joints – After that, you can use a slightly wet sponge to clean off the remaining grout. You need to take your time with this process and thoroughly clean all the tiles. Don’t put too much force to the point where you end up removing the freshly placed grout.

Step 7: Remove the Additional Haze – When the grout dries up, you are probably going to see a slight haze on the toles. You can use a simple piece of clothing to get rid of that. There is haze removing products available out there that you can also check out.

Step 8: Clean the Tiles – The final step is to completely wash all the tiles. But make sure to do it only when the grout is completely dried up. If wash when the grout is wet, it is going to remove the grout from the joints and you’d have to start all over again.

If you are looking for Bathroom Partitions for your office, you should check out this guide by stans tips.

Wrapping Up

Bathroom Tiles Regrouting doesn’t have to be a struggle. You can do that by following a simple process that we have described in this article. We have talked about all the steps that you need to do to complete the regrouting job for your bathroom tiles. You can use the same process for routing any other kinds of floor or wall tiles around your home.